Tanner is now included in the Mentor Graphics HEP.
The Tanner Suite offers products for the design, layout, and verification of analog, mixed signal, and MEMS designs. It consists of fully-integrated front-end and back-end tools, from schematic capture, circuit simulation, and waveform probing to physical layout and simulation.
The tools included in the suite are:
- L-Edit—tool for layout design, LVS, and, DRC (can also be used for MEMS designs); for more details, see http://s3.mentor.com/public_documents/datasheet/tannereda/l-edit-ds.pdf.
- S-Edit—tool for schematic capture; for more details, see http://s3.mentor.com/public_documents/datasheet/tannereda/s-edit-ds.pdf.
- T-Spice—tool for circuit simulation; for more details, see http://s3.mentor.com/public_documents/datasheet/tannereda/t-spice-ds.pdf.
- W-Edit—waveform viewing and analysis; for more details, see http://s3.mentor.com/public_documents/datasheet/tannereda/wavefrom-viewer-ds.pdf.
Note: L-Edit Viewer & S-Edit Viewer are not available through CMC Flex Licensing.
More information on individual Tanner products can be found online at https://www.mentor.com/tannereda/products.
|Software Versions and Operating Systems||Release 2016.2 Update 8 (FlexNet) Supported Platforms and Processors:
|Bit Level||32- and 64-bit|