Harvard Apparatus Pico Plus Pump

The Pico Plus infusion pump delivers low flow rates, either infusing or withdrawing fluid, at low to moderate back pressures. The device can hold any two syringes from 0.5 µl to 10 ml. The diameter and desired flow rate are entered via the keypad and stored in non-volatile memory. In the event of a power outage, the Pico Plus is equipped with “power failure mode” that allows the user to decide whether to turn the pump off or to resume pumping once power is restored. The pump can either operate in RATE mode, which continuously dispenses fluid at a specified rate, or the pump can release exact amounts of fluid in VOLUME mode.


  • Holds 2 syringes, plastic or glass, from 0.5 µl to 10 ml. Maximum 16 mm inside diameter
  • Flow rate range: 1.3 pl/min with 0.5 µl syringe to 0.4393 ml/min with 10 ml syringe
  • Automatic calibration based on entered syringe inside diameter


  • Procedures that require precise metering, particularly at the micro and nanoscale
  • Material development and characterization
  • Pharmaceuticals

What’s Included

  • Pico Plus syringe pump
  • Printed manual
  • Power Adapter


User manual & Datasheet

Rent this equipment

Does your research benefit from products and services provided by CMC Microsystems?

Open source design platforms for accelerated system development.

Scroll to Top
Skip to content